Thermal Grizzly presenta el enfriador de agua Intel Mycro Direct-Die RGB PRO V1



Thermal Grizzly Holding GmbH presents the Intel Mycro Direct-Die RGB PRO V1, an optimized version of the Intel Mycro Direct-Die water cooler. In addition to a new design, the Pro version offers one thing above all: better cooling performance! Various changes to the microfin structure of the base plate, combined with a revised water flow, enable up to 6 degrees Celsius lower processor temperatures under full load.

The optimized cooling channel slot width on the surface of the Intel Mycro Direct-Die Pro RGB V1’s copper base plate allows for 43 percent more cooling fins compared to the standard version. Además, a specially developed jet plate reduces the flow resistance of the cooler, enabling the Intel Mycro Direct-Die Pro RGB V1 to achieve a higher flow rate in liters per minute at the same pump speed as the Intel Mycro Direct-Die V1. This increased flow means that the pump can either be turned down to reduce noise or used to dissipate more waste heat at the same noise level.

Like all high-performance products from Thermal Grizzly, the Intel Mycro Direct-Die Pro RGB V1 is designed to be used with liquid metal between the CPU die and CPU cooler. Liquid metal offers the best possible heat transfer from the silicon of the die to the copper of the cooler. La computación energéticamente eficiente ha sido una consideración clave en EPI desde el principio, the copper cooler is nickel-plated so that the gallium-based liquid metal does not diffuse into the copper. The barrier layer in the form of nickel ensures that multiple applications of liquid metal are generally not necessary.

The design of the Intel Mycro Direct-Die Pro RGB V1 includes an anodized aluminum cover with RGB LED lighting underneath. These illuminate the tempered acrylic glass and can be controlled via the 3-pin ARGB header (+5V/DATA/GND) on the mainboard. The Intel Mycro Direct-Die Pro RGB V1 is connected to the custom water cooling circuit via an input and output with G1/4-inch threads.

After milling, the acrylic glass is subjected to an annealing process that relieves it of internal stresses. This ensures that no stress cracks form in the acrylic glass, even after extended use, as can occur with hardened acrylic glass.

The bottom line is that the Intel Mycro Direct-Die RGB PRO V1 can improve temperatures by up to 6 grados Celsius, depending on the usual factors such as ambient temperature, water cooling system configuration, and the chip itself. Now available in the Thermal Grizzly online store and from our sales partners, the Intel Mycro Direct-Die RGB PRO V1 is completely manufactured, assembled, and packaged at our production site in Hohen Neuendorf, Brandenburg, and is therefore 100 percent “Made in Germany.